Quanta Computer QuantaMesh - Page 642

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
642
5.28.2.7 mlag keepaliv-timeout
This command is used to specify the timeout (in seconds) between re-transmissions to the MLAG peer
device.
Syntax
mlag keepalive-timeout <3-20>
no mlag keepalive-timeout
<3-20> - Specify the timeout value between re-transmissions.
no – This command restore the setting to default value.
Default Setting
5
Command Mode
Global Config
5.28.2.8 mlag delay-restore
This command is used to specify the time to delay the MLAG from coming up on the restored MLAG
peer device aftera reload when the peer adjacency is already established.
Syntax
mlag delay-restore <5-600>
no mlag delay-restore
<5-600> - Specify the number of seconds to delay bringing up the restored MLAG peer device.
no – This command restore the setting to default value.
Default Setting
10
Command Mode
Global Config