Quanta Computer QuantaMesh - Page 721

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
721
6.3.2.52 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both parameters is
0-65535 seconds..
Syntax
timers spf <delay-time> <hold-time>
Default Setting
delay-time—5
hold-time—10
Command Mode
Router OSPF Config Mode
6.3.2.53 timers pacing flood
Use this command to configure the LS Update transmit pacing time to adjust the rate at which OSPFv2
sends LS Update packets. The valid range for both parameters is 5-100 seconds. Use the no timers
pacing flood command to return the timer pacing to the default.
value.
Syntax
timers pacing flood <flood-pacing-interval>
no timer pacing flood
Default Setting
33
Command Mode
Router OSPF Config Mode