Quanta Computer QuantaMesh - Page 722

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
722
6.3.2.54 timers pacing lsa-group
Use this command to tune how OSPF groups LSAs for periodic refresh. The valid range for both
parameters is 10-1800 seconds. Use the no timers pacing lsa-group command to return the timer
pacing to the default.
Syntax
timers pacing lsa-group <lsa-refresh-group-pacing-time>
no timers pacing lsa-group
Default Setting
60
Command Mode
Router OSPF Config Mode
6.3.2.55 max-metric
Use max-metric command to configure OSPF to enable stub router mode. Use no max-metric
command to disable stub router mode.
Syntax
max-metric router-lsa [on-startup <seconds> [summary-lsa] | summary-lsa [<metric> [on-startup
<seconds>] | on-startup <seconds>]
no max-metric router-lsa [on-startup] [summary-lsa]
on-startup - OSPF starts in stub router mode after a reboot.
seconds - The number of seconds that OSPF remains in stub router mode after a reboot. The range
is 5 to 86,400 seconds. There is no default value.
summary-lsa - Set the metric in type 3 and 4 summary LSAs to LsInfinity (0xFFFFFF).
metric - Metric to send in summary LSAs when in stub router mode. Range is 1 to 16,777,215.
Default is 16,711,680(0xFF0000).
Default Setting
None
Command Mode
Router OSPF Config Mode