Quanta Computer QuantaMesh - Page 836

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
836
7.2.2.4 ip igmp last-member-query-count
This command sets the number of Group-Specific Queries sent before the router assumes that there are
no local members on the interface.
Syntax
ip igmp last-member-query-count <1-20>
no ip igmp last-member-query-count
<1-20> - The range for <1-20> is 1 to 20.
no - This command resets the number of Group-Specific Queries to the default value.
Default Setting
2
Command Mode
Interface Config
7.2.2.5 ip igmp last-member-query-interval
This command configures the Maximum Response Time being inserted into Group-Specific Queries
sent in response to Leave Group messages on the interface.
Syntax
ip igmp last-member-query-interval <0-255>
no ip igmp last-member-query-interval
<0-255> - The range for <0-255> is 0 to 255 tenths of a second.
no - This command resets the Maximum Response Time being inserted into Group-Specific Queries
sent in response to Leave Group messages on the interface to the default value.
Default Setting
10 tenths of a second
Command Mode
Interface Config