18 ESP-LX Modular Controller
Set Watering Start Times
You may assign up to eight start times to a program per day.
Multiple start times allow you to run a program more than once on
each watering day.
For example, if you are growing new lawn seed, you may want to
water several times a day to keep the seedbed or top dressing damp.
NOTE: Start times apply to the entire program, not
to an individual valve.
Turn the dial to “SET WATERING START TIMES.”
The display shows the program, the number of the start time,
and the start time itself (or “OFF”). The start time flashes. If
the program you want is not displayed, use the program select
switch to change it. See page 17 for instructions.
Press “+” or “–” to set the start time. To turn off a start time,
press “+” or “–” until the display shows the “OFF” setting
between 11:59 p.m. and 12:00 a.m.
If you want to set additional start times, press “Next.” Then
repeat steps 2 through 4.
To Next Page
Loading...
Need help?
General
