ESP-LX Modular Controller 51
The hours and minutes flash.
Press “+” or “–” to set the amount of time you want to run this
valve (from 0 minutes to 12 hours). The run time will change
in one-minute increments until the time reaches two hours.
Then the run time will change in 10-minute increments.
To begin watering, press “Run.” The message “Watering”
appears in the display.
To operate additional valves, press “Next” and repeat steps 5
through 10. Each valve you operate will run when the previous
valve has ended.
After selecting all the valves you want to run, turn the dial to
“AUTO.” The valves you have selected will operate for the
times you entered. They will then shut off automatically.
While Valves Are Running
While the valve(s) are running manually and the dial is set to
“AUTO,” the display shows the valve currently watering and
the time left to water.
You can press“+” or “–” to add or subtract run time from the
valve that is currently running.
To advance to the next manually started valve in sequence,
press “Adv. Valve.” Go to step 1.
To Next Page
Loading...
Need help?
General
