ESP-LX Modular Controller 59
The display shows the currently selected program and the total
run time of the program from the time the first valves turns on
until the last valve turns off. If the program you want is not
displayed, use the program select switch to change it. See page
17 for instructions. Press “Back” to return to the Confirm
Programs menu.
NOTE: If Cycle+Soak™ is set for this program, a
message appears telling you that the actual run time
for the program will be longer than the time shown.
Valve Run Time
This function displays each valve in the system, along with the total
amount of actual watering that will occur in each program each day
the program is scheduled to run. This calculation includes multiple
start times and the effects of seasonal adjust percentages.
For example, assume that Valve 1 runs for 10 minutes in program
A, and program A has two start times per watering day. The total
valve run time would be 20 minutes. If a seasonal adjust percent of
80% were also in effect, the calculated run time would be 16
minutes.
Turn the dial to “TEST ALL VALVES/CHECK SYSTEM.”
The Check System menu appears.
Press “1” on the Check System menu.
To Next Page
Loading...
Need help?
General
