To Next Page

To Previous Page

- 23 - V08 en, SCC

To use the following functions connect a USB Stick to the USB interface

PIn - Load programs from USB Stick onto unit (Program In)

Pout - Load programs from unit onto USB Stick (Program out)

Programs can not be interchanged from SCC or SCC_WE to CM_P and vice versa.

Now set mode switch to Prog/Start and select desired additional program with temperature dial.

Import (Pin):

Should no „progs.xml“ le exist on the USB stick, Pin is blinking (Import not possible, Start key without function).

Should a „progs.xml“ le exist on the USB stick, Pin is showing steady. Import of programs is started by pressing

Start/Prog key. During the import time the Prog/Start-LED is blinking.

Export (Pout):

In case a „progs.xml“ le already exists on the USB stick, Pout is blinking;

Note: Pressing Start key now would overwrite the existing program le!

If Pout is showing steady the programs can be downloaded by pressing Start key. During the download process

the Prog/Start-LED is blinking.

Sout - Copy Service Data to stick

Hout - Copy HACCP Data to stick

As soon as the Start key is pressed, download starts and a LED is circling in the time display.

Program Lock

Select any program number, press timer key and set time to 110 min. Keep timer key pressed and press Prog/

Start key, “P” (Program Lock) is displayed.

When now selecting Prog/Start, “P---” is displayed for 2 seconds.

(Deactivation with same procedure.)

ESG - Empty Steam Generator manually (only with open door)

Close water tap

Press Start - SC pump runs for 45 seconds

°C°F - Setting °C >=< °F

Press Start - display changes from °C to °F or vice versa

rtc - (real time clock) Setting of date and time for HACCP protocol

Conrm the individual settings of hour, minute etc by pressing the START key.

Ethernet connection

Setting IP address: (only possible when Ethernet PCB is installed)

Select IP 1 for rst block. Set block number with timer pot. Press Prog/Start to conrm. Select IP2 with tempera-

ture dial etc.

Setting Gateway Address:

Aer entering IP 4 the display will switch over to GAt 1 automatically. Set block number with timer pot. Press

Prog/Start to conrm. Select GAt 2 with temperature dial etc.

Setting Subnet address:

Aer entering GAt 4 the display will switch over to Sub 1 automatically. Set block number with timer pot. Press

Prog/Start to conrm. Select Sub2 with temperature dial etc.

Additional function

Rational CombiMaster Plus CMP User Manual

Questions and Answers: