Rational CombiMaster Plus CMP User Manual

- 59 - V08 en, SCC
Cleanjet/CareControl SCC
Using any of the Cleanjet programs: Quick, Save, Medium or Strong will reset the bars of the Display Clean to 1
green bar (starting with soware version 05-00-09).
CleanJet +Care can only be started when the cabinet temperature is below 50°C (122°F).
1) Cleaner Tabs: 56.00.210 - for SCC index E, G, H and index I units
- for CM_P index I units
2) Rinse Tabs: 56.00.211 - only for SCC index E and CM_P index I units
2) Care Tabs: 56.00.562 - only for SCC index G - I units
The use of Rinse tab 56.00.211 in a SCC unit index G - I will lead to a blocked Care
pump and Service 40 error.
The condition of the indication depends on:
the use of the unit
the cleaning behaviour of the customer
the degree of scale in the steam generator (see information CDS).
Display Maintenance status - long term status display
1: very good care - arrow position green
2: medium care - arrow position yellow
3: neglected care - arrow position red
The request for Clean+Care has been neglected several times.
Only regular cleaning will reduce the display to one green bar again.
Display Cleanliness - short term / daily status display
Actual dirt status
1: arrow position green - no cleaning necessary
2: arrow position yellow - CleanJet request will show soon
3: arrow position red - Cleaning urgently required
CleanJet request is dependent on the usage pattern of the unit:
- SCC processes, - manual modes, - cooking programs, - duration, - temperatures
1 2 3
For demonstration of CleanJet+Care to the customer switch the unit rst to Demo
mode followed by switching o and on.
Now you can demonstrate the behaviour of the Maintenance and Cleanliness bar
by pressing on the individual bars.
In case an error 27, 40-44 is existing, Cleanjet*Care can not be started.
(ref. to error messages). Aer repair of 40 - 44, 110-120 a Rinse program (not rinse without tabs) or
full clean program must be run before another cleaning cycle is possible again. With soware ver-
sion 07-00-08 reset error by pressing Function test CleanJet in Service level.
In case an error 110 or 120 is existing, only an abort cycle of 27 minutes is oered and must be run
successfully before the unit can be used again.
Cleanjet programs: Each Cleanjet program starts with a components test
Rinse without tabs: Fresh water without chemical is pumped by M6 through the cabinet.
Rinse: Care chemical is pumped by M12 via the steam generator into the control
box and by M6 through the cabinet
Interim cleaning: Cleaner chemical is pumped through the cabinet by M6
Light, Safe, Medium, Strong: Cleaner chemical is pumped through the cabinet by M6. Aer that Care
chemical is pumped by M12 into the steam generator for descaling and part
of it into the control box and by M6 through the cabinet
Programs have dierent duration.

Rational CombiMaster Plus CMP Specifications

General

Brand	Rational
Model	CombiMaster Plus CMP
Category	Commercial Food Equipment
Language	English