RayTalk RA-696 - Terminal Auto Setup (TAS)



Method2:WirelessConnection

Fill in NetworkSettingsandWireless Settings,clic k Save, and reboot the system.After RT‐TO696RF and the uplink devicehas
successfullybuiltupaconnection,theStatusindicatorwillblinkwithlongilluminatedintervals.
Note:
 Whenwiredconnectionisestablished,the wirelesscon nectivitywillbeturnedoff by the
 systemautomatically,meaning
wirelessandwiredconnectionwillnotco‐existatanytime.
Wiredconnectionhasahigherpriority.
WhenthesettingsaredonecompletelyontheRayTalkHotSpotWi‐FiAccessPointorInternetSubscriberGatewaysi
de,gotoRT‐
TO696RF’sWMIandcheckifeveryuplinksettingmatchesthatonthecontroller.

TerminalAutoSetup(TAS–OnlyavailableonRT‐TO696RF)

TASreferstoanautomaticconnectionmechanismthatrequiresNOpreviousnetworksettings.Justpressthe
TASbuttononRT‐TO696RFforthreeseconds,anditwillautomaticallylookforandassociatetoasuitableRayTalkHotSpotWi‐Fi
AccessPointorInternetSubscriberGatewaythatsupportsthisfunction.
TheTASconnection will rewritethe previousmanual settings.You  will see the Uplinkpage of theWMIgrayedout as well as
StatusshowthatthesystemisinTASmode.
TASprocesstakesaboutthirtysecondsforcompletion.Whethertheconnections
ucceedsorfailstheattem pt,RT‐TO696RFwill
always have the printer print out if the connectionis
‘successful’ or it ‘failed.’Pleasemakesurebeforehandthatthe Ethernet
cableispluggedthewirelessenvironmentisok.

148