Safety
Intended use
8
3 Safety
Pos: 7 /ZINDEL/Rollref fanlagen/Identif ikation/Bestim mungsgemäße Verwendung R F90 @ 1\mod_1400501979336 _13349.docx @ 13930 @ 2 @ 1
3.1 Intended use
The RF90 is an advanced hydraulic furling system for fore sails.
The furling system is designed for reefing or furling a fore sail by rolling it up. It can be operated
either hydraulically or manually using a winch handle. The sail can be rolled up completely (furled)
or partially (reefed).
The furling system is equipped with a length adjuster for trimming of mast and sail. The length
adjuster should be used at the mooring, not when sailing.
Use as a forestay foil without reefing or furling function is also possible. In this case it must be
ensured that the hydraulic drive is not connected. The halyard swivel is lowered down to a position
below the sail feeder.
All controls for switching the furling system on and off are provided on board.
Pos: 8 /ZINDEL/Rollref fanlagen/Sic herheit/Sicherhei tshinweise @ 1\mod_140047911 9234_13349.doc x @ 13925 @ 2 @ 1
3.2 Safety instructions
• Read the instructions before using or working on the furling system.
• Always keep the instructions close to the furling system.
• In addition to this manual, the owner's manual for the yacht and manuals for other on-board
equipment must be observed.
To Next Page
Loading...