Troubleshooting
Coupling the gear
59
8.3 Coupling the gear
After the winch handle has been used the gear may remain decoupled from the drive. This can
happen if the clutch pin inside the winch handle socket does not spring back up when the winch
handle is removed.
If this is the case switch the hydraulic drive on and keep it on briefly until the foil starts rotating
again.
If the gear does not automatically become coupled, screw an M5 screw into the clutch pin and pull
out the pin. Then remove the screw.
Pos: 80 /ZINDEL/Rollref fanlagen/Demon tage/headline_De montage @ 1\mod_14121658285 15_13349.docx @ 14015 @ 1 @ 1
To Next Page
Loading...