Record CG3 - Default Chapter; Table of Contents

Table of Content
Thank You. ............................................................................... 1
How to use this manual ............................................................ 2
1.0 CG3 Components .............................................................. 2
1.1 A Note Concerning the RS-232 Cable Connector ............. 3
2.0 Wiring .............................................................................. 4
2.1 Grounding ........................................................................... 4
2.2 Vehicle Speed Signal (VSS) ............................................... 5
2.3 DC Power Requirements .................................................... 6
2.4 Fusing ................................................................................. 6
2.5 Relays ................................................................................. 6
3.0 CG3 User Interface ............................................................. 7
3.1 Config Switch ...................................................................... 7
4.0 CG3 Modes ..................................................................... 9
4.1 Vacant Mode .................................................................... 10
4.1.2 Displaying Time and Date ................................................. 11
4.2 Hired Mode ....................................................................... 12
4.2.1 Starting a Fare .................................................................. 12
4.2.2 Incrementing Extra Charges ............................................. 13
4.2.3 Toggling Rate time-charges Off / On ................................ 14
4.2.4 Ending the Fare ................................................................ 14
4.3 End-of-Fare Mode ............................................................ 15
4.4 Configuration Mode........................................................... 17
4.4.1 Configuration Menu........................................................... 18
4.4.2 Set Rates Mode ................................................................ 20
4.4.3 Calculating Drop Distances .............................................. 20
4.4.4 Programming Rates .......................................................... 21
4.4.5 Calibrating Mileage ........................................................... 23
4.4.7 Set the Signal-Conditioner Value (VSS Sensitivity), F2 .... 24
4.4.8 View / Manually Set Calibration Value .............................. 25
4.4.9 Calibration Procedure ....................................................... 26
4.4.10 Adjusting the Sensitivity during Calibration Test ............... 26