Record CG3 - Setting the Security Code

36
4.8 Setting the Security Code
The security code is an optional feature that can be used to lock a number of
features from being tampered with by unauthorized users, which includes the
following:
1) Clearing the total trips and statistics while in Audit mode.
2) Dispatch settings (4.4.12) access from the Main Menu.
3) Configuration Mode (4.4) – as of software version 1.21
By default, the security code is set to zero. You may set a 5-digit security code
to prevent unauthorized tampering.
NOTE: To prevent someone from accessing the value of your security
code, any previous security code will not be revealed in this step. Thus,
when doing this procedure, the display will always show zero, despite
whether or not a previous security code was set.
To set the security code:
1) Enter Configuration Mode (See section 4.4.1).
2) Press: 5 times.
 The display will show:
3) Press: .
 The display will now show the security code configuration interface:
4) Using the , , and buttons, set a security code consisting of 1 to
5 digits.
5) Press: to enter the code into memory and exit back to Vacant Mode.