5) To clear the total trips and total stats: Press , and the following will be
displayed:
Press . The following will now be displayed (“No):
This indicates that “No, I don’t wish to proceed”.
Pressing will promptly exit back to Vacant Mode.
Otherwise, Press , so that “Yes” is displayed:
Press to confirm that you wish to proceed with clearing the totals.
The following Security Code prompt will now be displayed:
If a Security Code was previously set in Configuration Mode
(4.4.12), use the , , and buttons to enter the 1 -5 digit
security code.
If no Security Code was previously set, then the default security
code is zero.
Press to proceed with the clear operation.
If successful, the display will flash “DONE”.
Otherwise, if the Security Code was entered incorrectly, the display will
flash “SORRY” and exit back to Vacant Mode. Repeat the above steps if a
mistake was made.
To Next Page
Loading...
