RED DSMC OPERATION GUIDE: EPIC/SCARLET
COPYRIGHT © 2015 RED.COM, INC 955-0020_V6.0, REV-J | 121
REDISCOVER (HARDWARE REDISCOVER)
Rediscovers all hardware and caches the data for future boot cycles. Perform a Hardware Rediscover if a
module or lens mount is not functioning correctly.
To perform a Hardware Rediscover, follow the instructions below:
1. Go to Menu > Settings > Maintenance.
2. Select Rediscover.
3. Select Yes on the screen that asks you to confirm the Hardware Rediscover.
The BRAIN turns off.
4. Turn on the BRAIN.
SYSTEM STATUS
The System Status menu displays key project and system information on the following tabs: Project Status,
Module Status, Camera Info, and Media Info.
PROJECT STATUS
Displays the current camera and project settings.
MODULE STATUS
Displays which modules are attached to the BRAIN.
Not Detected: The module is either not attached, or is not detected by the BRAIN.
Attached: The module is attached and detected.
CAMERA INFO
Displays the following camera information:
Type: Camera type (EPIC or SCARLET) and sensor type.
Firmware Version: Current firmware version.
PIN: The personal identification number that is specific to your camera.
SVN Revision: The current firmware number.
Runtime: The number of hours that the camera has been turned on.
MEDIA INFO
Displays the following media information:
Active Media: Active media, module type.
Model Number: Storage capacity, SSD type, and version/revision of the SSD.
Serial Number: Serial number of the SSD.
Firmware Version: Firmware version of the SSD.
Size: Total capacity on the SSD.
Size Available: Total capacity left on the SSD that can be recorded to.
NOTE: When an SSD is not attached, the Media Info tab displays “No Active Media is Present”.
OLPF
NOTE: The OLPF menu is only available on an EPIC DRAGON or SCARLET DRAGON.
RED offers multiple optical low-pass filters (OLPFs) for EPIC DRAGON and SCARLET DRAGON. Each OLPF
optimizes certain characteristics to take full advantage and control of each shooting environment. The camera
checks the OLPF type, and adjusts the color scienced based on the selected OLPF.
To Next Page
Loading...
Need help?
General
