- Materials holding methods for engraving bracelets
Place three bangle adapters in the rotation clamp, and tighten the chuck finger in front of the bangle adapters.
Open the rotation clamp to match it to the bracelet size, and insert the bracelet until it clicks into the chuck finger.
Use the chuck handle not to make bracelet come out or spin.
ā Pen Clamp
1. Turn the clamp knob on the left side of the clamp and pull the clamp and spacer block to take it out.
2. Place the pen in the flat chuck finger of the rotation clamp, and insert the pen clamp into the pen clamp adapter.
Push the clamp until it touches the pen fixed in the chuck finger. Tighten the bolt on the pen clamp adapter not the
pen clamp to be pushed, and tighten the bolt of the pen clamp to securely hold the pen.
To Next Page
Loading...