109
11.2 Dialog Controls
11.2.1 Back to Project
This returns to the full FDT Workspace view. This will be disabled if the user currently logged in to FDT
does not have the ‘FDT:Project Edit’ access. [see Chapter 5 for details]
11.2.2
Exit
Clicking this will exit FDT and FDT will start up in the Simple Interface Mode next time it is loaded. This
will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Exit’ access. [see
Chapter 5 for details]
11.2.3
Download Project image radio button
This will be disabled if the user currently logged in to FDT does not have the SimpleInterface:Download
Project Image’ access. [see Chapter 5 for details]
11.2.4
Program Flash \ Erase
Clicking on Program Flash allows FDT to download the specified file or image to the FLASH memory.
Additionally, if Readback Verify is switched off, the Checksum will also be calculated and output to the
screen. If in Batch Erase mode this button will switch to ‘Erase’ and will perform an entire device erase.
11.2.5
Disconnect
Clicking on Disconnect forces FDT to disconnect.
To Next Page
Loading...
General