29
3.5 Configuring a Project for a Generic Boot Device
It is also possible to connect to a Generic Boot Renesas Device - where you do not need a kernel or
configuration file installed, instead FDT extracts the required information from the device itself. Because of
this, the device must be connected and set into Boot Mode at the time you create the project. If a Generic
Boot device is selected, then a series of screens appear displaying the results of the inquiry functions, you
will be required to make selections about the device and clock mode (one boot program may be shared for
multiple devices).
3.5.1
New Project Workspace
Enter the workspace name, then click the ‘OK’ button. (Specify whether or not a directory is to be created
and a location.)
Figure 3-12 New Workspace
To Next Page
Loading...
General