User Manual Bearing System RT-300
Issue: 2017/06/27 [Rev 1.04.c] Page 6 of 79 12-9-1-0013-9-2-0001-3-1-60
6.3.2 Resetting Brightness and Contrast Adjustment of Display 62
6.3.3 Loading Firmware Updates 62
6.4 Interfaces 62
6.4.1 Antenna Connector on DCU 62
6.4.2 Power Connector 63
6.4.2.1 Power Supply 64
6.4.2.2 External Speaker 65
6.4.2.3 Alarm Contact 65
6.4.2.4 Extern Input 65
6.4.2.5 Analog Test 65
6.4.3 Interface Connector 65
6.4.3.1 RS-232-Interface 66
6.4.3.2 RS-485-Interface 66
6.4.3.3 NMEA (RS-422) Interface 66
7 INSTALLATION AND PUTTING INTO OPERATION 67
7.1 Installation of Display-Control-Unit DCU 67
7.1.1 DCU Installing Cut-Out 67
7.1.2 Connecting Power Supply 68
7.1.3 Connecting the DCU to Ground 68
7.1.4 Connecting Antenna 69
7.2 Determination of Antenna Position 69
7.3 Completing Antenna Cable 70
7.3.1 Type of Cable 70
7.3.2 Connecting Pattern of Antenna Cable: 70
7.4 Installing the Antenna 72
7.4.1 Fixing Screw Joint on Mast Tube 72
7.4.2 6-Holed Mast Flange 72
7.4.3 Installing Antenna Cable with Pull-Relief 72
7.4.4 Fixing the Antenna 73
7.4.5 Aligning Antenna for Mobile Use 73
7.4.6 Aligning Antenna for Stationary Use 73
7.4.7 Mounting of Antenna Beams 74
7.5 Configuring Setup 75
8 MAINTENANCE AND CLEANING 77
8.1 Maintenance 77
8.2 Cleaning 77
9 PRODUCT DISPOSAL 78
9.1 Disposal within the European Union 78
9.2 Disposal outside the European Union 78
10 APPENDIX 79
10.1 Wiring Pattern (recommended RT-300 DCU connections plan) 79
To Next Page
Loading...