User Manual Bearing System RT-300
Issue: 2017/06/27 [Rev 1.04.c] Page 49 of 79 12-9-1-0013-9-2-0001-3-1-60
- Keys 5 < + > respectively 8 < > and 10 < – > respectively 3 < > are increasing /
decreasing the interval.
- Key 6 < Ok > will confirm the adjustment.
- Key 9 < Clr > will reject the selection. The device will return to the next higher level of the
menu, working with the previous adjustment.
6.2.1.5.4 SETUP Menu: COMPASS
Via it´s NMEA-interface the bearing system is able to receive and
to process data of an external compass and data of the internal
compass module. These data are used to put out heading
information referring to north and to compensate drag errors caused by changes of heading.
In setup menu COMPASS the reference direction of the incoming data (magnetic / geographic)
is to be defined.
NOTE
For stationary use instead of compass data, constant values can be put in (see 6.2.1.5.4.4 ).
Following adjustments in submenu SETUP - COMPASS can be done:
Menu Short Designation Meaning see chapter
TRUE SOURCE Source for compass data referring to
geographic north:
- Static True
- Internal compass (optional)
- NMEA-data in format HCHDG
- NMEA-data in format XXHDT
- NMEA-data in format XXHDM
6.2.1.5.4.1
MAG SOURCE Source for compass data referring to
magnetic north:
- Static magnetic
- Internal compass (optional)
- NMEA-data in format HCHDG
- NMEA-data in format XXHDT
- NMEA-data in format XXHDM
6.2.1.5.4.2
STATIC TRUE Input of a constant angle as reference to
geographic north.
function required for stationary use
6.2.1.5.4.3
STATIC MAG Input of a constant angle as reference to
geographic north.
function required for stationary use
6.2.1.5.4.4
INT. COMPASS 6.2.1.5.4.5
Operating:
- In setup-menu select function COMPASS.
- The display will appear as shown in Fig. 71.
Fig. 71
M
n
SETUP COMPASS
To Next Page
Loading...