The Energy Saver Timer and Auto Off Timer start at the same time (t0) when the machine ends all jobs,
when the user ends all manual operations, or when the controller starts the default application program
(the program specified by the user [User Tools > System Settings > General Features > Function Priority]).
The default application program starts when the System Auto Reset Timer expires (User Tools > System
Settings > Timer Settings > System Auto Reset Timer).
Recovery
Any of the following operations brings the machine back to the Operating Mode:
• The power switch is pressed.
• Originals are set on the document feeder.
• The platen cover (or document feeder) is opened.
• The controller receives a job over the network or the telephone line.
• An SC code is generated.
7. Energy Saving
202
To Next Page
Loading...
