Service Call Conditions
SM Appendix 3-49 D062/D063/D065/D066
Appendix:
Service Call
Conditions
Motor harness or connector loose, broken, defective
Motor or motor drive board defective
Crease Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
783-5 B
Motor harness or connector loose, broken, defective
Motor or motor drive board defective
Dynamic Roller Transport Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
783-6 B
Motor harness or connector loose, broken, defective
Motor or motor drive board defective
Reg. Roller Transport Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
783-7 B
Motor harness or connector loose, broken, defective
Motor or motor drive board defective
Dynamic Roller Lift Motor Error Multi Folder (D454)
The dynamic roller HP sensor did not detect the dynamic roller in (or
out of) its home position within the prescribed time. The 1st occurrence
causes a jam, and the 2nd occurrence causes this SC code.
783-8 B
Dynamic roller HP sensor dirty
Sensor harness or connector loose, broken, defective
Dynamic roller lift motor harness or connector loose, broken,
defective
Sensor defective
Motor or motor drive board defective
To Next Page
Loading...
Need help?
General