Service Program Mode Tables
D062/D063/D065/D066 4-88 SM Appendix
CE Login
5169
If you will change the printer bit switches, you must 'log in' to service mode with
this SP before you go into the printer SP mode.
[0 to 1/1]
0: Off. Printer bit switches cannot be adjusted.
1: On. Printer bit switches can be adjusted.
5179 By-pass tray paper size error display
Set the by-pass tray paper size error display to ON/OFF.
0: OFF / 1: ON
HDD Page Mgmt
5182
These SP codes are used to change the configuration of the TEMP partition for
raw data on the HDD so the local storage (LS) area can be expanded.
The SP codes below cannot be set together.
If one is selected that SP is enabled and the other reset to its default value.
For example, if 002 is set to on (1) when 001 is already set to on (1), 002 will
be set to on (1) and 001 will automatically reset to its default value (0:
Normal).
Release LS Limit
001
Normally LS can handle up to 15,000 pages. Use this SP code to select
expansion of the page storage area.
[0 to 1/0/1]
0: Normal, 1: Allow Expansion
Change Pages/Doc
002
The configuration of the TEMP area on the HDD must be changed in order to
increase the number of pages that 1 document can hold when it is stored on the
HDD. If the size of the LS area is increased, the size of the TEMP area must be
decreased. Changing this SP increases the default value for the size of the LS
area from 5,000 pages to 20,000 pages. A larger setting is not possible.
To Next Page
Loading...
Need help?
General