Using Auto Erase Memory
• When Auto Erase Memory is set to [On], temporary data that remained on the hard disk when
Auto Erase Memory was set to [Off] might not be overwritten.
• If the main power switch is turned off before Auto Erase Memory is completed, overwriting will stop
and data will be left on the hard disk.
•
Do not stop the overwrite mid-process. Doing so will damage the hard disk.
• Should the main power switch be turned off before Auto Erase Memory is completed, overwriting
will continue once the main power switch is turned back on.
• If an error occurs before overwriting is completed, turn off the main power. Turn it on, and then
repeat from step 1.
1. The machine administrator logs in from the control panel.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [
] eight times.
5. Press [Auto Erase Memory Setting].
6. Press [On].
7. Select the method of overwriting.
If you select [NSA] or [DoD], proceed to step 11.
If you select [Random Numbers], proceed to step 8.
8. Press [ ].
4. Preventing Leakage of Information from Machines
108
To Next Page
Loading...
Need help?
General
