Controller Options
SM 2-92 D017/D018/D019/D020/D084/D085
2.23.2 IEEE 1284 INTERFACE BOARD (B679)
Accessories
Check the accessories and their quantities against the following list:
No Description Quantity
1 IEEE 1284 Interface Board B679 1
Installation
Turn off the main power switch and disconnect the power supply cord.
1. Remove the application cover (
x1).
2. Remove the cover [A] of the board slot (
x1).
3. Install the interface board [B] (
x2 knob screws).
Use a screwdriver to tighten the knob-screws. Do not tighten manually,
because this can disconnect the board.
4. Reattach the application cover (
x1).
If the 500-Sheet Finisher is installed, remove it before you attach the parallel
cable. Install the finisher again after you connect the parallel cable.
To Next Page
Loading...
