Copy Adjustments: Printing/Scanning
D017/D018/D019/D020/D084/D085 4-71 SM
Replacement
and
Adjustment
4.10 COPY ADJUSTMENTS: PRINTING/SCANNING
You must do these adjustment(s) after replacing any of the following parts:
Scanner Wire
Lens Block/SBU Assembly
Scanner Drive Motor
Polygon Mirror Motor
Paper Side Fence
Memory All Clear
For more details about accessing SP modes, see Service Tables.
4.10.1 PRINTING
Make sure the paper is installed correctly in each paper tray before you start these
adjustments.
Use the Trimming Area Pattern (SP2-902, No.10) to print the test pattern for the
following procedures.
Set SP 2-902 to 0 again after completing these printing adjustments.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration for each paper feed station, and adjust them using
SP1-001.
2. Check the side-to-side registration for each paper feed station, and adjust them using
SP1-002.
Tray SP mode Specification
Any paper tray SP1-001-1
3 ± 2 mm
By-pass feed SP1-001-2
Duplex SP1-001-3
1st paper feed SP1-002-1
2 ±1.5 mm
2nd paper feed SP1-002-2
To Next Page
Loading...
