Photoconductor Unit (PCU)
SM 4-32 D017/D018/D019/D020/D084/D085
PCU Reassembly
Reassemble the PCU in this order:
1. Connect the pawl [A]
2. Frame pawls [B], front and rear
3. Set the rear cover and front cover [C]
Never touch the lever [D] until after the top screw has been fastened.
4. Screws ( x3), coupling x1 [E]
Never press down on the top of the PCU when you reattach the rear or front cover.
5. Lower screw (
x1) [F]
Always install the lower screw first to maintain the correct gap between the rollers.
6. Top screw (
x1) [G]
Lift and lower the lever [D] to make sure that the shutter opens fully and operates
smoothly.
To Next Page
Loading...
