Ricoh D017 - Page 255

Copy Adjustments: Printing/Scanning
D017/D018/D019/D020/D084/D085 4-75 SM
Replacement
and
Adjustment
 The following procedure should be done after adjusting the side-to-side registration
for each paper tray station.
1. Check whether the trimming area pattern (SP2-902, No.10) is printed as a
parallelogram, as shown. If it is, do the following.
2. Remove the laser unit [A] (
p.4-20).
3. Remove the bracket [B] (
x2).
4. Install the adjusting cam [C] (P/N: A2309003).
5. Secure the adjustment bracket [D] (P/N A2679002) using the screw which was used for
bracket [B]. However, do not tighten the screws at this time.
6. Adjusts the laser unit position by turning the adjusting cam. (Refer to the above
illustration for the relationship between the image and the cam rotation direction).
7. Tighten the adjustment bracket.
8. Print the trimming area pattern to check the image. If it is still unsatisfactory, repeat
steps 4 to 8.