Firmware Update
D017/D018/D019/D020/D084/D085 5-15 SM
System
Maintenance
5.2 FIRMWARE UPDATE
The procedure is the same for all firmware modules.
Before you start the firmware upgrade procedure, make sure that the machine is
disconnected from the network. This is to prevent a print job from being received while the
upgrade is in progress.
If you will change scanner firmware, print 5-990-22 and -23 (SMC reports for
scanner settings) before you start this procedure.
1. Stop all SDK applications if the VM card is installed (
p.2-102 "HDD Encryption
Unit").
2. Turn off the main power switch.
3. Remove the plastic application cover [A] (
x 1).
4. Remove the VM card from SD card slot 2 if it is installed.
5. Insert the SD card [B] containing the software you wish to download into SD card slot 2
(lower slot).
6. Open the front cover.
7. Turn on the main power.
8. Follow the instructions on the operation panel
⇒
Rev. 02/08/2012
To Next Page
Loading...
