Image Problems
D017/D018/D019/D020/D084/D085 6-13 SM
Trouble -
Shooting
ADF mode check
Feed an original through the ADF.
Is the image skewed?
No Yes
Do the front and rear
transport rollers feed the
original straight?
No Yes
Change the position of the
right hinge screw to the
longer hole, and make
small position adjustments
that are necessary.
Do Procedure B below.
Procedure complete.
Procedure A
1. Remove the rear and left covers, then the left scanner cover.
2. Check to see if there is a gap between the scanner unit holder and frame at [A].
3. If there is no gap, the left front section of the scanner unit is lower than the standard
position.
To Next Page
Loading...
