Service Call Conditions
D017/D018/D019/D020/D084/D085 3-52 SM Appendix
875 D
Delete All error 2: Data area
An error occurred while the machine
deleted data from the HDD.
Note: The source of this error is the
Data Overwrite Security Unit D362
running from an SD card.
Turn the main switch off/on,
and try the operation again.
876 D Log data abnormal
An error was detected in the handling
of the log data at power on or during
machine operation. This can be
caused if you turn the machine off
while it is operating.
Software error. Update the
firmware
NVRAM defective
HDD defective
877 D
Data Overwrite Security SD card error
The 'all delete' function did not
execute but the Data Overwrite
Security Unit (D362) is installed
and activated.
Replace the NVRAM
Reinstall the DOS from the SD
card
SD card defective
878 D
TPM electronic recognition error
The main machine firmware failed to recognize
TPM because USB flash is not operating or a
system module was updated incorrectly.
Replace the
controller board
To Next Page
Loading...
