System SP Tables-2
SM Appendix 4-23 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
2913*
ID Test Pattern
Adjusts the image density level for black pixels on test pattern printouts
(patterns are made with SP2902)
[0 to 15 / 15 / 1/step]
This SP affects all test patterns except for the grayscale test patterns.
2915*
Polygon Motor Idling Time
Selects the polygon motor idling time.
The polygon motor starts rotating up to its operation speed if the user 1) sets
an original, 2) touches a key, or 3) opens the platen cover or document
feeder. This shortens the time to the first copy. However, with the default (10
s) set, the motor stops if the user does nothing for 10 s after doing one of the
actions above, and stops 10 s at the end of a job.
Note: If set at "0", the polygon motor never turns off during stand-by.
However, when the machine goes into energy saver mode, the polygon
motor turns off regardless of this timer.
1 Idling Time Adj.
[0 to 60/10/1]
2 Post Idling Time Adj.
2921*
Toner Supply Mode
Selects the toner supply mode.
[0 = Sensor 1 / 1 = Sensor 2 / 2 = Fixed 1 / 3 = Fixed 2, 4 = Sensor 3]
Normally, only use setting 0. Change to 3 temporarily if the TD sensor is
defective. Do not use settings 1, 2 and 4; these are for designer's use only.
To Next Page
Loading...
