System SP Tables-2
SM Appendix 4-29 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
2995* ID Sensor Detection Interval
1
Warming-up
This SP controls the temperature at which the ID sensor pattern is created
after the machine is turned on, or after the machine returns to full operation
from the energy saver or auto off mode.
[0 to 255 / 30 / 1 degree]
2
Number of Pages
The machine makes an ID sensor pattern after the specified number of
prints has been made.
[0 to 999 / 300 / 1 page/step]
3 Job End/Interrupt
Determines when the ID sensor reads the ID sensor pattern.
0: Job End. Read pattern at job end.
1: Interrupt. Read pattern at interval set with SP2995-2, even if the job is not
completed.
To Next Page
Loading...
