System SP Tables-5
SM Appendix 4-69 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
5055*
Display IP Address
Display or does not display the IP address on the LCD.
[0 to 1 / 0 / 1]
0: OFF, 1: ON
5056* Coverage Counter Display
Display or does not display the coverage counter on the LCD.
[0 to 1 / 0 / 1]
0: Not displayed, 1: Displayed
5061* Toner Remaining Icon Display
Display or does not display the remaining toner display icon on the LCD.
[0 to 1 / 0 / 1 ]
0: Not display, 1: Display
5104*
A3/DLT Double Count (SSP)
Specifies whether the counter is doubled for A3/DLT. "Yes" counts except
from the bypass tray. When "Yes" is selected, A3 and DLT paper are
counted twice, that is A4 x2 and LT x2 respectively.
5106*
Density Level Setting
Selects the image density level used in ADS mode.
[1 to 7 / 4 / 1 notch per step]
Example: If you set SP5106 to "2": Pressing the Auto Image Density key
toggles the display off and manual notch 2 is selected.
Adjust this SP if the customer cannot attain clean copies after performing
automatic density adjustment
To Next Page
Loading...
