Bit Switches - 1
D361/D510 76 SM
System Switch 00 (SP No. 1-101-001)
No Function Comments
5
G3/G4 communication
parameter display
0: Disabled
1: Enabled
This is a fault-finding aid. The LCD shows the
key parameters (see below). This is normally
disabled because it cancels the CSI display for
the user.
Be sure to reset this bit to 0 after testing.
6
Protocol dump list output after
each communication
0: Off
1: On
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always
reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
7 Not used Do not change the setting.
To Next Page
Loading...
