Bit Switches - 4
D361/D510 130 SM
G3 Switch 00 (SP No. 1-105-001)
No Function Comments
3-5 Not used Do not change the settings.
6
G3 mode selection for the direct
connection
0: Off
1:On
1: G3 communication through the direct line
is enabled.
7 Not used Do not change the settings.
G3 Switch 01 (SP No. 1-105-002)
No Function Comments
0 Not used Do not change the settings.
1-3 Not used Do not change the settings.
4
DIS frame length
0: 10 bytes 1: 4 bytes
1: The bytes in the DIS frame after the 4th byte
will not be transmitted (set to 1 if there are
communication problems with PC-based faxes
which cannot receive the extended DIS frames).
5 Not used Do not change the setting.
6
Forbid CED/AMsam output
0: Off
1: On (Forbid output)
Do not change this setting (Default: 0: Off),
unless communication problem is caused by a
CED or ANSam transmission.
7 Not used Do not change the setting.
To Next Page
Loading...
