Ricoh D017 - Page 982

NCU Parameters
D361/D510 164 SM
Address Function Unit Remarks
68054F
Time waited when a pause is
entered at the operation panel
SP2-103-017 (parameter
16). See Note 3.
680550 DTMF tone on time
1 ms
SP2-103-018 (parameter
17).
680551 DTMF tone off time
SP2-103-019 (parameter
18).
680552
Tone attenuation level of DTMF
signals while dialing
-N x 0.5 –3.5
dBm
SP2-103-020 (parameter
19).
See Note 5.
680553
Tone attenuation value
difference between high
frequency tone and low
frequency tone in DTMF signals
-dBm x 0.5
SP2-103-021 (parameter
20).
The setting must be less
than –5dBm, and should
not exceed the setting at
680552h above.
See Note 5.
680554
PSTN: DTMF tone attenuation
level after dialling
-N x 0.5 –3.5
dBm
SP2-103-022 (parameter
21). See Note 5.
680555
ISDN: DTMF tone attenuation
level after dialling
-dBm x 0.5 See Note 5
680556 Not used
Do not change the
settings.
680557
Time between 68054Dh (NCU
parameter 14) and 68054Eh
(NCU parameter 15)
1 ms
This parameter takes
effect when the country
code is set to France.
680558 Not used
Do not change the
setting.