System Service Mode
SM Appendix 9-53 D037/D038/D040/D041
Appendix:
SP Mode
Tables
2220 [Skew Origin Set]
001 C:Skew Motor *ENG
002 M:Skew Motor
003 Y:Skew Motor
-
[LD Power: Fixed] LD Power Control
2221
Adjusts the fixed LD power for each line speed and color.
These SPs are activated only when SP3-041-002 is set to "0".
Normal: 120 mm/sec, Low: 60 mm/sec
001 Bk:Normal Spd *ENG
002 C:Normal Spd *ENG
003 M:Normal Spd *ENG
004 Y:Normal Spd *ENG
009 Bk:Low Spd *ENG
010 C:Low Spd *ENG
011 M:Low Spd *ENG
012 Y:Low Spd *ENG
[0 to 200 / 100 / 1%/step]
Increasing this value makes the
image density darker.
[Dev. DC Bias:Fixed] Development DC Bias Adjustment
2229
Adjusts the development bias.
Development bias is automatically adjusted during process control; therefore,
adjusting these settings has no effect while Process Control (SP3-041-001
Default: ON) is activated.
After deactivating Process Control with SP3-041-001, the values in these SP
modes are used for printing.
Normal: 120 mm/sec, Low: 60 mm/sec
001 Plain: Bk *ENG
[0 to 800 / 450 / 10 –V/step]
To Next Page
Loading...
