System Service Mode
D037/D038/D040/D041 9-160 SM Appendix
NOTE:
If the toner collection bottle has been replaced before the machine detects used
toner near full when this setting is set to "0", the machine cannot detect toner
collection bottle near full. In that case, set SP3-902-017 to "1".
Day Thresh:NF *ENG
[1 to 30 / 10 / 1 day/step]
012
Sets the threshold days for the near-full display. The near-full of the toner
collection bottle is displayed after the toner collection full sensor has detected
the actuator in the toner collection bottle.
013 Total Collected Toner *ENG
Displays the total amount of the used
toner.
[0 to 999999999 / 1 / 1]
014 Full Detected Date *ENG
Displays the date of the full detection
for the toner collection bottle.
3810 [ITB T-Collection Bttl Full]
001 Condition *CTL
[0 to 4 / 0 / 1 /step]
002 Detection Times *CTL
[0 to 50 / - / 1 /step]
003 Print Page Af Near Full *CTL
[0 to 2000 / 0 / 1 sheet/step]
004
Pixel Count After Near
Full
*CTL
[0 to 200000 / - / 1 cm
2
/step]
005
Pixel Count Af
Replacement
*CTL
Displays the pixel counter after
replacement of toner collection bottle.
[0 to 200000 / - / 1 cm
2
/step]
008 Coefficient *ENG
[0.1 to 1 / 1 / 0.1 /step]
011
Notice Setting *ENG
Enables or disables the calling for
@Remote.
[0 or 1 / 1 / - ]
0: Enable @Remote calling
1: Disable @Remote calling
To Next Page
Loading...
