Service Mode Table
G160/G161 5-120 SM
Function.
[0 or 1 / 0 / 1/Step] Alphanumeric
0: OFF, 1: ON
5857 002 Target *CTL
Sets the storage location for the debug log.
[2 or 3 / 2 / 1/step]
2: HDD, 3: SD
5857 005 Save to HDD *CTL Sets the key number of the debug log.
5857 006 Save to SD Card *CTL Sets the key number of the debug log.
5857 009 HDD to SD Latest *CTL
Copies the most recent 4 MB of the debug log
from the hard disk to the SD card.
5857 010 HDD to SD Any *CTL
Sets the key number of the debug log copied
from the hard disk to the SD card.
5857 011 Erase HDD Debug *CTL Deletes the debug log from the hard disk.
5857 012 Erase SD Debug *CTL Deletes the debug log from the SD card.
5857 013 Dsply-SD Space *CTL Shows the free space on the SD card.
5857 014 SD to SD Latest *CTL
Copies the most recent 4 MB of the debug log
from an SD card to a different SD card.
5857 015 SD to SD Any *CTL
Sets the key number of the debug log copied
from an SD card to a different SD card.
5857 016 Make HDD Debug File *CTL
5857 017 Make SD Debug File *CTL
Makes a log file on the HDD to save debug
logs. To save debug logs, the controller
makes a log file first, then writes data in the
file. This procedure can use much time. The
user can switch off the main power switch
before the log is written in the file. To prevent
this possible problem, you can prepare a log
file in advance. If you do this, the controller
uses less time to save logs because the log
file is prepared.
5858 [Debug Log Save: SC]
5858 001 Engine SC *CTL
Collects debug logs when an engine-related
SC code occurs.
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
To Next Page
Loading...
