Ricoh G179 - Drum Cleaning Blade 1; Drum Cleaning Blade 2; Re-Installation

PCDU
SM 3-19 G179
Replacement
Adjustment
3. Remove cleaning blade 2 [A]. ( x 1, bushing x 1)
Re-installation
 Engage the left end of the cleaning blade first, then make sure that both arms [B] and
[C] are through the holes on the left and right side.
 When you re-attach the snap-ring, make sure that the head of the snap ring [D] is
below the blade.
 After re-assembly make sure that the front spring of the movable cleaning blade is
re-attached to the ,  position. ( Drum)
3.5.6 DRUM CLEANING BLADE 1
1. Drum ( Drum)
2. Charge roller and cleaning roller ( Charge Roller and Cleaning Roller)
3. Drum cleaning blade 2 ( Drum Cleaning Blade 2)
4. Remove drum cleaning blade 1 [A] ( x 2)
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA