Image Transfer and Paper Separation
G179 6-50 SM
current depends on SP 2-301. This is different for various parts of the image, and is
different for the by-pass tray; see the next page for details.
Currents applied to leading edge, image areas - by-pass feed
Transfer current can also be adjusted for the leading edge and the image area, and for
by-pass feed. The timing for starting to apply leading edge current, for the switchover from
leading edge current to image area current, and for switching off at the trailing edge can
also be changed.
The table below lists the SP modes you can use to adjust these settings.
SP2-301 Transfer Current Adjustment
SP2-301-1 1st Side of Paper
SP2-301-2 2nd Side of Paper
Image areas
SP2-301-5 By-pass Feed
SP2-301-3 Leading Edge 1st side
SP2-301-4 Leading Edge 2nd side
Leading edge areas
SP2-301-6 Leading Edge By-pass Feed
SP2-911 Transfer Current Timing
SP2-911-1 On Timing (at leading edge)
SP2-911-2
Switch Timing (from leading edge to
image area current
Timing
SP2-911-3 Off Timing (at trailing edge)
To Next Page
Loading...
