Using SP Modes
G179 5-154 SM
Check the nip bandwidth around the center of the OHP.
Nip band Specification: 7.0 ± 0.5 mm
5.26.4 MEMORY CLEAR: SP5-801
Executing Memory Clear resets all the settings stored in the NVRAM to their default
settings, except the following:
SP5811-1: Machine serial number
SP5907: Plug & Play Brand Name and Production Name Setting
This procedure restores all SP code settings to their factory default settings.
Before clearing all settings in memory with SP5801, print an SMC report with
SP5990. You may need this for reference to restore previously adjusted settings.
1. Push " and $ together, hold down for over 5 seconds, release and then press the
"OK" button.
2. Press " or $ to display “2.Engine”.
3. Press the "OK" button.
4. Press " or $ to display “5.Mode” then press the "OK" button.
5. Press " or $ to display “SP5801/Memory Clear” then press the "OK" button.
6. With “ALL Clear” displayed, press the "OK" button, then press the "EXECUTE" button.
7. With "Would you like starting…" displayed, then press the "EXECUTE" button again to
execute.
<All>
result=OK
Here is a summary of all the settings.
No. Item What It Initializes
001 All All items in this table
002 Clear Engine All settings set for engine and processing
To Next Page
Loading...
