Using SP Modes
G179 5-152 SM
5.26 USING SP MODES
5.26.1 TEST PATTERN PRINTING
Always print a test pattern to confirm correct operation of the machine.
1. Enter the SP mode and select SP2-109.
2. Enter the number for the test pattern that you want to print and press "OK" button (see
the tables below). This selects the test pattern for printing.
You can check the test patterns on the LCD by pressing the "Details" button
on the operation panel.
3. Exit the SP mode.
4. Press the "Menu" button, and then select "List/Test Print".
5. Press the "OK" button, and then select "Operations Test".
6. Press the "OK" button, and then press the "Print" button.
You can select which tray paper is fed from and which tray paper is output to
at this time.
Test Pattern Table (SP2-109-001: Printing test pattern)
No. Test Pattern No. Test Pattern
0 None 13 Independent Pattern (4-dot)
1 Vertical Line (1-dot) 14 Trimming Area
2 Vertical Line (2-dot) 15 Hound's Tooth Check (Vertical)
3 Horizontal Line (1-dot) 16 Hound's Tooth Check (Horizontal)
4 Horizontal Line (2-dot) 17 Black Band (Horizontal)
5 Grid Vertical Line 18 Black Band (Vertical)
6 Grid Horizontal Line 19 Checker Flag Pattern
7 Grid Pattern Small 20 Grayscale (Vertical Margin)
8 Grid Pattern Large 21 Grayscale (Horizontal Margin)
To Next Page
Loading...
