Self-Diagnostic Mode
SM 5-167 G179
Service
Tables
5.30.3 EXECUTING DETAILED SELF-DIAGNOSIS
Follow this procedure to execute detailed self-diagnosis manually.
1. Switch off the printer.
2. Press and hold down the [Suspend/Resume] and [OK] buttons together, then switch on
the printer.
3. Release the buttons when you see:
DIAGNOSE
0200
4. The number will change automatically as the self-diagnostic test runs. After about 30
seconds, the initial display returns and a self-diagnostic report prints.
5. A report like the one below is printed every time a detailed self-diagnostic test is
executed, whether errors were detected or not.
To Next Page
Loading...
