Development
G179 3-24 SM
3.6.4 TD SENSOR
1. PCDU ( PCDU (Photoconductor and Development Unit))
2. Empty all developer from the development unit. ( Developer)
3. Seal
4. TD sensor [A] ( x1)
The TD sensor is attached to the casing with double-sided tape [B]. Pry it off
with the flat head of a screwdriver. Use fresh double-sided tape to re-attach
the sensor.
5. Pour new developer into the development unit and perform the TD sensor initial setting
using SP2-801.
When performing the TD sensor initial setting, cover the toner entrance hole
with a piece of paper.
To Next Page
Loading...
