Print Adjustments
SM 3-75 G179
Replacement
Adjustment
1. Laser unit [A]
2. Bracket [B] ( x2)
3. Install adjustment cam [C] (P/N: A2309003).
4. Secure positioning pin [D] (P/N A2309004) with the two screws removed with the
bracket [B]. Do not tighten the screws at this time.
5. To adjust the position of the laser unit [E]
1) Adjust the laser unit position by turning the adjustment cam. (See the illustration
above.)
2) Tighten the adjustment bracket.
3) Print the trimming area pattern to check the image. If the results are not satisfactory,
repeat steps "5-1)" to "5-3)".
To Next Page
Loading...
