SP5-xxx: Mode-3
G179 5-68 SM
when the machine started up with DHCP.
Active IPv4 Gateway Address
023
This SP allows you to confirm the IPv4 default gateway setting that was
used when the machine started up with DHCP.
050
1284 Compatibility
(Centro)
Enables and disables bi-directional
communication on the parallel connection
between the machine and a computer.
[0 to 1 / 1 / 1 ]
0:Off, 1: On
052 ECP (Centro)
Disables and enables the ECP feature (1284
Mode) for data transfer.
[0 to 1 / 1 / 1]
0: Disabled, 1: Enabled
065 Job Spooling
Switches the job spooling on and off.
[0 to 1 / 0 / 1]
0: No spooling, 1: Spooling enabled
066
Job Spooling Clear: Start
Time
This SP determines whether the job interrupted
at power off is resumed at the next power on.
This SP operates only when SP5828-065 is set
to "1".
[0 to 1 / 1 / 1]
1: Resumes printing spooled jog.
0: Clears spooled job.
Job Spooling (Protocol)
This SP determines whether job spooling is
enabled or disabled for each protocol. This is a
8-bit setting.
[0 to 1 / 1 / 1]
0: No spooling, 1: Spooling enabled
0 LPR 4 BMLinks (Japan Only)
069
1 FTP (Not Used) 5 DIPRINT
To Next Page
Loading...
