Using Debug Log
G179 5-170 SM
For details about SC code numbers, please refer to the SC tables in Section "4.
Troubleshooting".
1. Select "SP5858-003".
5.858.003 Any SC
0000
(0000)
2. Push the "OK" button.
3. Push " or $ to display the number in the 1st line.
4. Push - or . to move the cursor.
5. Input the desired SC code number with the ", $, - or . and "OK" buttons.
6. Push the "Escape" button twice.
7. Do the next procedure to select one or more memory modules for the debug error data
recording.
To select one or more memory modules for recording in the debug log
file
1. Select SP5859.
2. Input the desied SC code number with the ", $, -, . and "OK" buttons.
3. Push the "Escape" button twice.
The default settings for Keys 1 to 10 are all zero (“0”).
Select the number from the table below, then use these key presses to enter the number.
Refer to the table below for the 4-digit numbers to enter for each key. (The acronyms in
parentheses indicate the names of the modules.)
4-Digit Entries for Keys 1 to 10
Key No. Printer Web
1 2222 (SCS)
2 2223 (SRM)
3 256 (IMH)
To Next Page
Loading...
